PCF

Worm geared motor 130 W and three-phase motor. Centre distance 32 mm.

MOTOR: Three-phase 2-pole asynchronous motor, totally enclosed. Built-in thermal cutoff. Winding Class H. Protection IP67 in compliance with IEC/EN 60529 standards.

GEAR UNIT: with worm screw and die-cast aluminium gearcase. 32 mm centre distance. CARO bronze crown with a hardness of 120÷160 HB. The worm is made of tempered steel, with ground thread. Seal rings in special high-temperature rubber. Lubrication with special long-lasting oil for use with foodstuffs (H1). There are 10 gear ratios available, from 5 to 100.

White epoxy paint protective coat.

Version B3 – B5 (B5/S left – B5/D right).

ALWAYS specify application environment.

N.B. To choose the right gear motor, please refer to the relevant charts for duty and maximum shaft load coefficients.

These gear motors need to be run in. Therefore, for approximately the first 30 operating hours the torque will be lower than what indicated in the data.